PRODUCTS SEARCH

NOTE- IQSE-W1 - WiFi data trasmission - Note: no Blipper - to be matched with specific harness (sold separately) - including sensor - if harness is not indicated, contact us

NOTE- IQSE-W2 - WI-FI - works also on motorcycles without battery or charging system - Note: no Blipper - to be matched with specific harness (sold separately) - including sensor - if harness is not indicated, contact us

NOTE- QSH-CKP - to be matched with QSE module

NOTE- QSH-P2T (F21512) - to be matched with QSE module

NOTE- GPDT-H01 - Connects to Diagnostic port - no modification - available in Red, Blue, Green, Yellow, White - use HT-GIPRO-M to fit on handlebar

NOTEGPXT + GPX-H04 - no modifications required - including specific wire loom - available in Red, Blue, Green, Yellow, White

NOTE- gear indicator, shift light and high speed warning light - use HT-GIPRO-M to fit on handlebar - no modifications required - to be matched with specific wire loom - available in Red, Blue, Green, Yellow, White

NOTEGPX-H04 - use with GIpro X display

NOTE- SH-V4 - use specific wiring - Yamaha FJR1300 (2013-21) and XTZ 1200 use 2 units with two harness kits - with max speed memory - match to proper harness kit

NOTE- SH-V4AB - with setting recall switch - match to proper harness kit

NOTESH-H10

NOTE- use 2 units on VFR800, VT750C, VTX1800 plug'n'play lambda eliminator

NOTE- (F21036) - use HT-GIPRO-M to fit on handlebar

NOTE- not to be used on BMW (F21030) - Use on motorcycles, ATV and cars without light fault control (both bulb or LED)

NOTE- use with 2 x 76423005 lambda sensor eliminator - including ignition and rev limiter management

NOTE- use 2 units on VFR800 00-07, CBR600RR 04, CBR1100XX 01-05, VT750 from 2009

NOTEDouble lambda sensor - for twins - to be used with Power Commander V o 6

NOTESensor needed - E4-129, E4-130, E4-115 or E4-116 and 321040xx rods - Connectors supplied for Denso coils; wired for Honda, Suzuki and Triumph - Works on ignition - independently from a Power Commander

NOTE- kit for one single carburator - float needle, float bowl gasket, O-ring

NOTE- 380x390mm - WARNING: on Yamaha FZ8 use with HKSG fittings (MR4025066131990) - doble bubble - WARNING - UNIVERSAL - to be used with specific fitting kit