NOTE- for MTV2M05A, MTV2M05B, MTV2M170, MTV2R08

NOTEAdjustable Single stage RPM limiter designed for high side engine over-rev protection - for 1 to 6 cylinder engines

NOTEfor use with 2 coil systems and is perfectly compatible with the Dyna S and Dyna 2000 ignition systems - not compatible with coil on plug systems.

NOTEcompatible with Twincam and Harley M8 ignition systems - for use with 2 coil systems - compatible with the Dyna S and Dyna 2000 ignition systems - not compatible with coil on plug systems.

NOTE2007-2012 EFI model Harley-Davidsons - comes with OEM style connectors for a direct plug in connection at the coil. It is not compatible with coil on plug systems.

NOTE- for Dyna 2000 - cable extension included

NOTE- for FS ignition units

NOTE- Dyna 2000 - 4 cyl. prog. module only - replacement ignition box - to use preferably with Dynatek coils

NOTE- replacement harness - not suitable for DDK1-12 and DDK2-12P

NOTESPARE DYNA III MODULE for DKD37-1 - replacement ignition box - to use preferably with Dynatek coils

NOTESPARE DYNA III PICK-UP PLATE FOR DKD37-1 KIT - replacement ignition box - to use preferably with Dynatek coils

NOTESpare pick up rotor for DS2-1

NOTEsingle point to be used with point ignitions

NOTEdual points to be used with point ignitions

NOTE- Dyna FS - map switch preprogrammed with 4 selectable timing curves - reprogrammable with kits available separately

NOTE- match with cable kit Programmable piggy-back CDI Ignition for tuned engines

NOTEUniversal harness - 4 cylinder

NOTE2 UNIT BOX - 3 ohm - dual output - suggested for Dyna S non-Harley - check fitting guide in area DOWNLOAD - CATALOGUES - use with Dynatek Spark Plug Wire

NOTE2 UNIT BOX - 0.5 ohm - single output - check fitting guide in area DOWNLOAD - CATALOGUES - use with Dynatek Spark Plug Wire

NOTE0.5 ohm - single output - check fitting guide in area DOWNLOAD - CATALOGUES - use with Dynatek Spark Plug Wire