PRODUCTS SEARCH

NOTE- IQSE-W1 - WiFi data trasmission - Note: no Blipper - to be matched with specific harness (sold separately) - including sensor - if harness is not indicated, contact us

NOTE- QSH-P2T (F21512) - to be matched with QSE module

NOTEGPXT + GPX-Y01 - no modifications required - including specific wire loom - available in Red, Blue, Green, Yellow, White

NOTE- gear indicator, shift light and high speed warning light - use HT-GIPRO-M to fit on handlebar - no modifications required - to be matched with specific wire loom - available in Red, Blue, Green, Yellow, White

NOTEGPX-Y01 - use with GIpro X display

NOTE- SH-V4 - use specific wiring - Yamaha FJR1300 (2013-21) and XTZ 1200 use 2 units with two harness kits - with max speed memory - match to proper harness kit

NOTE- SH-V4AB - with setting recall switch - match to proper harness kit

NOTE(F21076) - on ABS equipped FZ8 use HT-SH-U01

NOTE- (F21036) - use HT-GIPRO-M to fit on handlebar

NOTESensor needed - E4-129, E4-130, E4-115 or E4-116 and 321040xx rods - Connectors supplied for Denso coils; wired for Kawasaki, Yamaha - Works on ignition - independently from a Power Commander - Note: no Blipper

NOTE- kit for one single carburator - float needle, float bowl gasket, O-ring

NOTE- replacement ignition box - to use preferably with Dynatek coils

NOTE2 UNIT BOX - 3 ohm - single output (2 sets for Yamaha V-Max) - check fitting guide in area DOWNLOAD - CATALOGUES - use with Dynatek Spark Plug Wire

NOTE- Dyna Wire - graphite - black 7mm 1x120 cm - 90 degree plug caps

NOTE- Dyna Wire - graphite - grey - 8mm - 1x120 cm - 90 degree plug caps

NOTE- more info on www.probolt-italy.com

NOTE- Yamaha - only for use on Ibex Zieger numberplate support