PRODUCTS SEARCH

NOTE- IQSE-W1 - WiFi data trasmission - Note: no Blipper - to be matched with specific harness (sold separately) - including sensor - if harness is not indicated, contact us

NOTE- QSH-P2B - to be matched with QSE module

NOTE(F21258) - Connects to Diagnostic port - no modification - available in Red, Blue, Green, Yellow, White - use HT-GIPRO-M to fit on handlebar

NOTE- SH-V4 - use specific wiring - Yamaha FJR1300 (2013-21) and XTZ 1200 use 2 units with two harness kits - with max speed memory - match to proper harness kit

NOTE- SH-V4AB - with setting recall switch - match to proper harness kit

NOTE(F21069) - Z1000: on ABS equipped models 07-09 use HT-SH-K06 - W800: on E/F/G/J type use HT-SH-U01

NOTE79mm x 43mm x 20mm - 5 analogue / 2 digital channels, GPS antenna - can be integrated with ARA - can be used with a smartphone as a display - complete kit

NOTE- use 2 units on Suzuki Intruder C/M 1800R - Triumph Scrambler only with LCD odo - PAIR system eliminator module

NOTE- (F21036) - use HT-GIPRO-M to fit on handlebar

NOTE- not to be used on BMW (F21030) - Use on motorcycles, ATV and cars without light fault control (both bulb or LED)

NOTE- use with lambda eliminator 76423007 - including ignition and rev limiter management

NOTE- 3amp/36W needed - to be used with Power Commander V o 6

NOTE- complete kit with button activation

NOTE- use with lambda eliminator 76423015 (250) or 76423007 (300) - specify map

NOTE- use with PC V, CMD, Wide Band 2, Auto Tune

NOTEpush/pull - on 2 injector per cylinder bikes use Ignition Module, SFM, QEM (code QEM10 to QEM17) - need harness modification to fit E4-120, E4-124, E4-126

NOTEonly valid in reference to stock - for aftermarket rearsets check the rod measures table

NOTESensor needed - E4-129, E4-130, E4-115 or E4-116 and 321040xx rods - Connectors supplied for Denso coils; wired for Kawasaki, Yamaha - Works on ignition - independently from a Power Commander