PRODUCTS SEARCH

NOTE- airbox removal required - use clamp on filters

NOTE- can be matched to the following coils: DKDC4-1, DKDC1-1, DKDC1-2 - replacement ignition box - to use preferably with Dynatek coils

NOTE- pick-up holder plate + rotor - spare Dyna 2000 DKDDK2-1

NOTEuse DKDC1-1 coils - replacement ignition box - to use preferably with Dynatek coils

NOTE2 UNIT BOX - 3 ohm - dual output - suggested for Dyna S non-Harley - check fitting guide in area DOWNLOAD - CATALOGUES - use with Dynatek Spark Plug Wire

NOTE- Dyna Wire - copper - black 7mm 2x120 cm

NOTE- Dyna Wire - copper - red 7mm 2x120 cm

NOTE- Dyna Wire - graphite - nero 7mm 2x120 cm

NOTE- Dyna Wire - grey - 8mm 2x120 cm

NOTE15-33-092 DID630V R - std size including rear and front sprockets (unless otherwise specified) - with SUPERSPROX sprockets (if not available, alternative sprockets could be AFAM, ESJOT, Chiaravalli or other quality parts)

NOTE1650 g - length 148mm x depth 67mm x height 140mm - equivalent YUASA YTX20(L)-BS, YTX24HL-BS - WARNING: these batteries are ONLY fit for use on motorcycles and scooters and DO NOT USE on any other type of vehicle or application

NOTEstage 1 & 3

NOTE- kit for one single carburator

NOTE- can be matched to the following coils: DKDC4-1, DKDC1-1, DKDC1-2 - replacement ignition box - to use preferably with Dynatek coils

NOTE- pick-up holder plate + rotor - spare Dyna 2000 DKDDK2-1

NOTEuse DKDC1-1 coils - replacement ignition box - to use preferably with Dynatek coils

NOTE2 UNIT BOX - 3 ohm - dual output - suggested for Dyna S non-Harley - check fitting guide in area DOWNLOAD - CATALOGUES - use with Dynatek Spark Plug Wire

NOTE- Dyna Wire - copper - black 7mm 2x120 cm

NOTE- Dyna Wire - copper - red 7mm 2x120 cm

NOTE- Dyna Wire - graphite - nero 7mm 2x120 cm