PRODUCTS SEARCH

NOTE- IQSE-W1 - WiFi data trasmission - Note: no Blipper - to be matched with specific harness (sold separately) - including sensor - if harness is not indicated, contact us

NOTE- QSH-P2T (F21512) - to be matched with QSE module

NOTE- SH-V4 - use specific wiring - Yamaha FJR1300 (2013-21) and XTZ 1200 use 2 units with two harness kits - with max speed memory - match to proper harness kit

NOTE- SH-V4AB - with setting recall switch - match to proper harness kit

NOTE(F21087)

NOTE- use with specific harness kit - can also be used on motorcycles with OEM Traction Control - Traction control, Anti-Wheelie, Launch Control, Pit Limiter

NOTE- on motorcycle NOT equipped with ABS add wheel speed sensor kit

NOTE79mm x 43mm x 20mm - 5 analogue / 2 digital channels, GPS antenna - can be integrated with ARA - can be used with a smartphone as a display - complete kit

NOTE- (F21036) - use HT-GIPRO-M to fit on handlebar

NOTE- not to be used on BMW (F21030) - Use on motorcycles, ATV and cars without light fault control (both bulb or LED)

NOTE- including ignition and rev limiter management

NOTEpush/pull - on 2 injector per cylinder bikes use Ignition Module, SFM, QEM (code QEM10 to QEM17) - need harness modification to fit E4-120, E4-124, E4-126

NOTEfits with OEM centerstand - from 2021 onward fitting kit 3014314602R could be needed and has to be purchased separately if it is not found in the box - race only - not EC approved - complete with all fittings for the model specified

NOTE- race only - not EC approved - complete with all fittings for the model specified

NOTE- euro 4/5 - fits with OEM centerstand - Carbon silencer - EC approved - complete with all fittings for the model specified

NOTE- euro 4/5 - fits with centerstand - stainless steel with carbon end cap - EC approved - complete with all fittings for the model specified

NOTE- black stainless steel with carbon end cap - NOT EC approved - complete with all fittings for the model specified

NOTE- Carbon silencer - race only - complete with all fittings for the model specified