PRODUCTS SEARCH

NOTE- (F21036) - use HT-GIPRO-M to fit on handlebar

NOTEALL J1850 ECM HARLEY-DAVIDSON MODELS - for Delphi ECU equipped motorcycles

NOTE- Kit with bungs - to be used with Power Vision

NOTE- designed for Dynojet dyno’s equipped with Dynoware EX+ and a Gen4 exhaust gas pump. - service shops only

NOTE- designed for Dynojet dyno’s equipped with Dynoware RT - service shops only

NOTE- service shops only

NOTE- not suitable for CVO - including ignition and rev limiter management and O2 sensor eliminator - including ignition and rev limiter management

NOTE- J1850 models (4pin) - with 2 lambda sensors and weld bungs included - to be used with Power Commander V o 6 - weld bungs included

NOTEbuilt in shift rod - to be used with a Power Commander - suggested bike model matching only for stock shift

NOTE- cuts fuel injection - Dyna: forward controls only - including sensor

NOTEQUICKSHIFTER FOR HARLEY-DAVIDSON BIG TWINS - STAND-ALONE KIT (EV-1 CONNECTORS) - including sensor

NOTE- HKS28-32 - fitting kit - handlebar diam 28-32mm - for MRA windshields

NOTEDOES NOT SUPPORT ITALIAN NUMBERPLATE - numberplate support area 170x790mm - stainless steel - no modification needed for fitment - LED numberplate light included

NOTEimproved manageability

NOTE1650 g - length 148mm x depth 67mm x height 140mm - equivalent YUASA YTX20(L)-BS, YTX24HL-BS - WARNING: these batteries are ONLY fit for use on motorcycles and scooters and DO NOT USE on any other type of vehicle or application