PRODUCTS SEARCH

NOTE- IQSE-W1 - WiFi data trasmission - Note: no Blipper - to be matched with specific harness (sold separately) - including sensor - if harness is not indicated, contact us

NOTE- QSH-P2F - to be matched with QSE module

NOTEHT-GPXT + GPX-D01 - no modifications required - including specific wire loom - available in Red, Blue, Green, Yellow, White

NOTE- gear indicator, shift light and high speed warning light - use HT-GIPRO-M to fit on handlebar - no modifications required - to be matched with specific wire loom - available in Red, Blue, Green, Yellow, White

NOTEGPX-D01 - use with GIpro X display

NOTE- SH-V4 - use specific wiring - Yamaha FJR1300 (2013-21) and XTZ 1200 use 2 units with two harness kits - with max speed memory - match to proper harness kit

NOTE- SH-V4AB - with setting recall switch - match to proper harness kit

NOTE(F21082) - non ABS - on ABS equipped Monster 1100 models use HT-SH-U01

NOTE- use with specific harness kit - can also be used on motorcycles with OEM Traction Control - Traction control, Anti-Wheelie, Launch Control, Pit Limiter

NOTE- on motorcycle NOT equipped with ABS add wheel speed sensor kit

NOTEincluding 2 discs (D11 + DR6) - wheel speed sensor kit

NOTE79mm x 43mm x 20mm - 5 analogue / 2 digital channels, GPS antenna - can be integrated with ARA - can be used with a smartphone as a display - complete kit

NOTE- (F21036) - use HT-GIPRO-M to fit on handlebar

NOTE- use with PC V, CMD, Wide Band 2, Auto Tune

NOTEonly valid in reference to stock - for aftermarket rearsets check the rod measures table

NOTE- check in variants if the screen has the hole for OEM position light or not - as OEM

NOTE+ 50mm - CHECK IN VARIANTS IF THE HOLE FOR OEM POSITION LIGHT IS PRESENT - double bubble

NOTE- No position light fitting (410-D108: with hole) - as OEM

NOTE- No position light fitting - use 400-D104 for position light - (double bubble)

NOTE- "Cone" type - including screw and including mounting hardware for almost all handlebars from 12mm to 22mm inside diameter. - do not use on H-D or Kawasaki handlebars with M8 thread