PRODUCTS SEARCH

NOTE- 4mm - 100mm adjustment - 580/675mm

NOTE- Made from 4mm acrylic

NOTE- bar-end included - pair - only available in matt black

NOTEwith integrated crash post (spare: RDPVPKN-0-16) - steel - left and right side and fitting kit - COMPATIBILITY WITH OTHER PARTS: use only RDmoto parts if not otherwise indicated

NOTE- steel - left and right side and fitting kit

NOTE- steel - left and right side and fitting kit - USE ONLY WITH RDmoto LOWER BARS KITS unless otherwise indicated

NOTE- steel 27mm diam. - left and right side and fitting kit - compatible only with other Ibex Zieger parts

NOTE- aluminium - powder coating - 3mm thickness

NOTE- aluminium - 4mm thickness

NOTEcompatible with Kriega, Touratech or SW-Motech support plates - can be used with Z10011796 plate

NOTE- "Cone" type - including screw and including mounting hardware for almost all handlebars from 12mm to 22mm inside diameter. - do not use on H-D or Kawasaki handlebars with M8 thread

NOTE- 4 bolts + wellnuts - choose colour - more info on www.probolt-italy.com

NOTE- 6 nuts M10x1.25x10mm - drilled for safety wire - choose colour

NOTE- 10mm thread, length 30mm - choose colour

NOTE- Clutch and rear brake master cylinder cover

NOTE- M8x50 - bolts + nuts - more info on www.probolt-italy.com

NOTE- 4 bolts + wellnuts - more info on www.probolt-italy.com

NOTE- M10x1.25 - 6 units - more info on www.probolt-italy.com

NOTEmore info on www.probolt-italy.com - Warning: coloured finish on titanium could take longer to deliver if not readily available